How to Clean a Washing Machine Naturally and Stop Odors
Your towels come out of the wash smelling faintly of damp cellar, and the rubber seal on the door has grey speckles you cannot scrub away.

Your towels come out of the wash smelling faintly of damp cellar, and the rubber seal on the door has grey speckles you cannot scrub away. If you want to clean a washing machine naturally, without a bottle of bleach-based drum cleaner, you can do it with white vinegar, baking soda, an old toothbrush and about two hours, most of which the machine spends running on its own.
I have cleaned machines in rented flats and my own utility room, and the pattern holds every time. The smell is rarely coming from the drum itself. It comes from three hidden places that trap lint, soap residue and water: the door seal, the detergent drawer and the drain filter. Clean those properly and the drum cycle becomes the easy part.
Why washing machines start to smell
Modern machines use less water and lower temperatures than they did twenty years ago. That is good for your energy bill, but it means detergent and fabric softener do not always rinse away completely. The leftover film is a perfect surface for mould and bacteria, especially in a machine that stays closed between loads.
Three habits make it worse:
- Washing almost everything at 30 or 40 degrees, so nothing ever gets hot enough to melt the residue.
- Using more detergent than the dose line, which leaves suds and gunk behind.
- Shutting the door straight after a load, so the drum stays humid for days.
What you need to clean a washing machine naturally
Everything on this list costs a few pounds or dollars and probably sits in your cupboard already:
- 500 ml of plain white vinegar (5 percent acidity is standard)
- 120 g, roughly half a cup, of baking soda
- An old toothbrush and a microfibre cloth
- A shallow tray or baking dish for the drain filter
- A few drops of tea tree oil, optional, for stubborn mould spots
If you already make your own sprays from our guide to natural cleaning that actually works, a bottle of half vinegar and half water will cover the wiping jobs below.
Step by step: the full clean
1. Scrub the door seal
On a front loader, pull back the rubber gasket gently and look inside the fold. You will usually find hair, a stray sock thread, coins and a dark ring of residue. Pick out the solid bits by hand, then make a paste of 2 tablespoons of baking soda and 1 tablespoon of water. Work it into the fold with the toothbrush, wait ten minutes, and wipe it out with a cloth dampened in vinegar spray. For black spots that do not lift, add 3 drops of tea tree oil to a cup of water, spray, and leave it on for an hour before wiping.
Be honest with yourself here: if the black marks are deep inside the rubber rather than on the surface, no cleaner will remove them. They are stains now, not active growth, and the only fix is replacing the seal, which costs around 30 to 60 dollars in parts plus an hour of careful fitting.
2. Soak the detergent drawer
Most drawers pull out completely if you press a small tab, often marked "push", at the back of the softener section. Soak the drawer in a sink of hot water with 2 tablespoons of baking soda for 20 minutes, then scrub the corners and the siphon cap. While it soaks, use the toothbrush on the drawer housing inside the machine, where a slimy crust tends to build up on the roof.
3. Empty the drain filter
This is the step most people skip, and it is often the source of the smell. The filter usually sits behind a small panel at the bottom front of the machine. Put down a towel and the shallow tray first, because 300 ml to 1 litre of grey water can come out. Unscrew the filter slowly, let it drain, then rinse the filter under the tap and clear any lint or hair from the housing. Screw it back in firmly and check for drips before moving on.
4. Run the vinegar cycle
Pour 500 ml of white vinegar directly into the empty drum, not the drawer. Run the hottest cycle your machine has, often a 60 or 90 degree cotton wash or a dedicated drum clean programme. The heat and acid break down soap scum and limescale together.
5. Run the baking soda rinse
When the vinegar cycle finishes, sprinkle 120 g of baking soda across the drum and run a short hot wash or a rinse and spin. This lifts loosened residue and leaves the drum smelling neutral rather than like a salad. Then wipe the drum, the glass and the seal dry with a microfibre cloth.
Do not mix vinegar and baking soda in one go
You will see plenty of advice telling you to pour vinegar and baking soda into the drum together for a "foaming deep clean". I would skip it. The fizz looks impressive, but the two react and neutralise each other within seconds, leaving you with mostly salty water and a little carbon dioxide. You lose the acidity that dissolves limescale and the mild alkalinity that lifts grease.
Running them in separate cycles takes about 40 extra minutes, but each one does its own job.
A second caution: some manufacturers warn that frequent, concentrated vinegar can wear rubber seals and hoses over years. Once a month at the dose above is fine for most machines. Using a full litre every week is not a good trade.
A monthly routine that keeps the smell away
A full clean every four to six weeks is enough for a family of four. In between, a few small habits do most of the work:
- Leave the door and the detergent drawer ajar for at least an hour after each load, or permanently if you have no small children or pets.
- Take laundry out within 30 minutes of the cycle ending.
- Wipe the door seal dry once a week. It takes 20 seconds.
- Use the dose line on your detergent, or slightly less in soft water areas.
- Run one hot wash a week, for towels or bedding, so residue never builds up for long.
If you are switching to plant-based detergents or soap nuts as part of a wider effort, our list of small changes that make a home more sustainable covers which swaps make a real difference and which are mostly packaging.
In hard water areas, limescale on the heating element adds to the problem. A monthly vinegar cycle handles light scale well, and the same principle works on taps and shower screens, as explained in our guide on how to remove hard water stains naturally.
Frequently asked questions
How often should you clean a washing machine?
Do a full clean every four to six weeks, and clear the drain filter every two to three months. If you wash pet bedding, cloth nappies or work clothes often, move to every three weeks. A weekly wipe of the door seal stops most smells before they start.
Can vinegar damage a washing machine?
At around 500 ml once a month, vinegar is safe for most machines. Problems come from heavy, frequent use, which can dry out rubber seals and hoses over time. If your manual specifically warns against vinegar, use baking soda alone and a hot cycle instead.
Why does my washing machine still smell after cleaning?
The most common reason is a drain filter that was never emptied or a blocked drain hose. Check the filter first, then look for standing water in the seal fold. If the smell persists after both, the drain hose or the sump may need a technician to inspect it.
More in Natural Home
Natural Home
How to Get Rid of Clothes Moths Naturally at Home
You lift a lambswool jumper out of the wardrobe in late October and there are two holes near the elbow, clean edged, no...
Natural Home
How to Stop Window Condensation Naturally in Winter
The first properly cold week of November is when the messages start.
Natural Home
How to Remove Hard Water Stains Naturally at Home
The chalky white crust around your taps comes back a week after you scrub it, and the shower screen looks foggy no matter how...